8BitDo’s Mod Kit turns wired NGC controller into wireless one with Hall Effect joysticks

If you wish to again play games on your Nintendo console with the GameCube controller that has damaged wires and bad instances of drifting analog sticks, then this accessory arrives as a blessing in disguise. 8BitDo has introduced a mod kit that lets you upgrade your GameCube controller to a wireless gamepad, so that you’re not impulsively tempted into buying a new one.

This is not the first time 8BitDo has introduced a mod kit for the Nintendo controllers including the N64 and earlier ones, so this comes as no surprise. The trick here is that you’ll have to replace the existing PCB of the NGC controller with a drop-in board. The Chinese tech company is taking pre-orders for this useful gaming accessory that’ll make you go wireless if you hate the wire clutter on your Nintendo ecosystem. Called the NGC Mod Kit, this one is slated to ship on 25^th September.

Designer: 8BitDo

You’ll need to have basic soldering knowledge and loads of patience to make the changeover. Remember, controllers are not that easy to put together when opened up. Although not as tedious as putting together something like a DualSense. Of course, there are certified adapters on the market (including 8BitDo GBros and Nintendo’s official adapter) that allow you to use the wired GameCube controller with the Switch but this mod kit cuts out the extra and brings straightforward wireless Bluetooth connectivity.

Along with making your gamepad wireless, there are other add-ons as well. It has Hall effect joysticks for improved lifespan and immunity against sensitive vibrations if you love to play your FPS games hard. The accessory adds a 300mAh USB-C rechargeable battery with 6 hours of playtime for gaming without interruptions. It also adds a new set of triggers to the controller, so basically, you’ll have a virtually new gaming controller to play around with.

8BitDo Mod Kit priced at $26 is worth the spend if you have a Nintendo GameCube controller with chewed-down wires and defunct joystick controls. The only catch is, that you’ll have to slash out another $26 for the Tetro Receiver for GNC to connect to the GameCube. So, spending $52 on a wire-free setup for your existing NGC controller makes logical sense.